Centos 7 network setup

0 votes
I am using wifi. I am unable to setup network in centos 7.Kindly guide me how to configure the network. I am using it on Virtual Box.
Jul 5, 2019 in Linux Administration by Shri
857 views

1 answer to this question.

+1 vote

Power off the VM and then go to network settings in the Virtual box

Set Adapter 1 as NAT and Adapter 2 as Hosts Only Adapter as shown below:

image

image

Now start the VM and then try to access the internet.

answered Jul 5, 2019 by Vasini
Thanks Vasini!

Related Questions In Linux Administration

0 votes
1 answer

How to increase Swap Memory in CentOS 7?

Follow the below steps and procedures: Prerequisites Must have ...READ MORE

answered Oct 5, 2018 in Linux Administration by Frankie
• 9,830 points
15,360 views
0 votes
1 answer

"connect: Network is unreachable?" error on ping

You need to set your default gateway. ...READ MORE

answered Jan 23, 2019 in Linux Administration by Tina
27,977 views
0 votes
1 answer

CentOS Error: 64 bit bad ELF interpreter

In my experience, a single yum command will ...READ MORE

answered Jun 20, 2019 in Linux Administration by Shubham
• 13,490 points
1,932 views
+1 vote
0 answers

Could not start the machine edureka_host_vm because the following physical network interfaces were not found:

Could not start the machine edureka_host_vm because ...READ MORE

Jan 28, 2020 in Linux Administration by Harish
• 130 points
789 views
0 votes
1 answer

How to configure SSH server in RHEL/CentOS?

Hi@MD, To configure SSH server to your system, ...READ MORE

answered Mar 30, 2020 in Linux Administration by akhtar
• 38,230 points
781 views
0 votes
2 answers

activation of network connection failed in Linux.

नेटवर्क कनेक्शन चाहिए READ MORE

answered Aug 18, 2020 in Linux Administration by anonymous
• 140 points
16,695 views
0 votes
1 answer
0 votes
1 answer

How do I set variable if a specific package version is installed in CFEngine?

Here is what you can do.Just use packagesmatching to ...READ MORE

answered Jul 12, 2018 in Other DevOps Questions by Atul
• 10,240 points
943 views
0 votes
1 answer
0 votes
1 answer

Using FIWARE to start Cygnus as a Service in IoT Solution

Cygnus is supposed to create /var/run/cygnus/ when started. You ...READ MORE

answered Aug 13, 2018 in IoT (Internet of Things) by anonymous2
• 4,280 points
720 views
webinar REGISTER FOR FREE WEBINAR X
REGISTER NOW
webinar_success Thank you for registering Join Edureka Meetup community for 100+ Free Webinars each month JOIN MEETUP GROUP